Ductwork is where Florida homes lose the most cooling
In a typical house, about 20 to 30 percent of the air that moves through the duct system is lost to leaks, holes, and poorly connected ducts (ENERGY STAR, Duct Sealing). In a Florida attic that bakes all summer, the loss is often worse. Fouraker Mechanical tests, repairs, seals, and replaces residential duct systems across Greater Jacksonville and Nassau County so your equipment can do its job and every room reaches the temperature on the thermostat.
What We Offer
Duct Repair and Sealing
Disconnected flex duct in the attic, torn duct board, crushed runs, or mastic that gave up years ago. These leaks drive up energy bills and cause hot or cold rooms. We locate every breach with diagnostic tools and seal or repair it properly.
New Duct System Installation
When an old duct system is too far gone to repair economically, a full replacement is the right call. We design a new layout to match your equipment's airflow requirements, eliminate dead zones, and seal every joint before closing the attic. The result is even temperatures in every room.
Duct Inspection and Maintenance
We include a duct system evaluation with every HVAC tune-up. If we find issues, you get a written report with repair options and pricing. Regular inspection catches small leaks before they turn into major energy losses or indoor air quality problems.
Financing Available
Flexible Payment Options
Don't let cost stand between you and a comfortable home. We
offer financing through FTL Finance, with a fast, easy
application and options for homeowners across a range of
credit situations.
Duct sealing with mastic, not tape that fails in attic heat
Static pressure testing and airflow balancing
Flex duct, sheet metal, and fiberglass board systems
Zoning system installation
Duct leak testing with diagnostic equipment
Signs your ductwork is the problem
A lot of calls that start as 'my AC is not keeping up' end with a duct repair instead of an equipment repair.
Rooms that never reach the set temperature, especially at the end of long duct runs
High utility bills despite a newer, properly working HVAC system
Unusual dust levels, or dust blowing from the registers
Musty odors in certain rooms, a sign of leaks pulling attic or crawl space air into the system
Weak airflow at some registers and strong airflow at others
Ducts that are original to a home built before the mid-1990s
A static pressure test and a visual inspection tell us exactly what is happening inside the system. We do both before recommending anything.
Why Florida attics are so hard on ductwork
Most Greater Jacksonville homes run their ducts through an attic that reaches well over 120 degrees on a summer afternoon.
Heat gain: Cooled air travels through a hot attic and arrives warmer than it left the air handler, even in a sealed duct. Insulation value matters.
Tape failure: The adhesive on standard duct tape softens and lets go in attic heat. Joints that were taped at construction are often open within a few years.
Flex duct sag and crush: Flex runs that were not supported properly sag, kink, and restrict airflow. Stored items in the attic crush them.
Humidity and condensation: Leaky return ducts pull humid attic air into the system, which raises indoor humidity and feeds mold on the coil.
How we evaluate a duct system
We do not guess at ductwork. Here is the process.
Static pressure test: Measures how hard the blower is working against the ducts. High readings mean restriction, undersizing, or a dirty coil.
Visual attic inspection: Disconnected runs, crushed flex, open joints, missing insulation, and returns pulling from the attic.
Airflow at the registers: Confirms which rooms are starved and whether the trunk and branch sizing match the equipment.
Written report: What we found, what it is costing you, and your options from targeted sealing to full replacement, each priced.
Seal, repair, or replace
Not every duct problem needs a new system. We match the fix to what the test shows.
Seal: Joints and connections leak but the layout and sizing are fine. Mastic and proper collars close the gaps.
Repair: A few runs are crushed, disconnected, or torn. We replace those sections and seal the rest.
Replace: The system is undersized for the equipment, the duct board or flex is deteriorating, or the layout leaves rooms without supply. A redesigned system fixes comfort for good.
Zone: Two-story homes and large single-story layouts often benefit from zoning dampers so upstairs and downstairs get the airflow each actually needs.
Financing through FTL Finance is available for full duct replacements and for duct work bundled with a new system.
Ductwork and your indoor air
Leaky return ducts do more than waste cooling. They pull unfiltered attic and crawl space air into the system, bypassing the filter entirely.
That is why homes with duct problems often show dust, musty odors, and humidity that the AC cannot seem to control. Sealing the return side is one of the most effective indoor air quality improvements available, and it costs less than most equipment add-ons. Our indoor air quality guide covers the rest of the picture.
If your system is running but rooms are not comfortable, your bills have climbed without explanation, or your ducts are original to a home built before the mid-1990s, a duct evaluation is worth having. We test static pressure and airflow and give you a straight answer.
Can you replace ductwork in a finished home?
Yes. Most of the duct systems we replace are in finished homes. We access the attic and crawl space without opening walls in most cases.
Do you do duct cleaning?
Our focus is testing, sealing, repair, and replacement, which fix the cause of dust and odors rather than the symptom. Call (904) 945-5404 and describe what you are seeing and we will tell you honestly whether cleaning, sealing, or replacement is the right answer.
How long does a full duct replacement take?
Most single-family homes in Greater Jacksonville are completed in one to two days, depending on attic access and the number of runs.
Will new ducts lower my power bill?
If your current ducts are leaking a significant share of the air, yes. Sealed, properly sized ducts let the equipment reach the set point faster and run fewer hours. We can estimate the difference from the static pressure test.
Should I replace ducts when I replace the AC?
Often, yes. A new high-efficiency system on leaky or undersized ducts never delivers its rated capacity. We test the ducts on every replacement quote and tell you whether they need attention.
What Our Customers Say
5-Star Reviews from NE Florida Homeowners
"Joel was such a great guy and came after hours to fix an ac problem for us. Got here super fast and fixed the problem even faster. We will def use him again and appreciate just the kind customer service.....We don't see that often anymore and it was pleasant to know it will exists"
Crystal G.
Google review
"Outstanding service and professionalism. Joel got right to the source of the problem and was able to get the system back up and running in no time! Fair and honest pricing, making this company an asset to have on speed dial!"
Douglas M.
Google review
"Fouraker Heating & AC has been servicing our system for over 9 years. They are very reliable and always go out of their way to fix the issue as soon as possible. They have always been very nice. Their prices are amazing. I highly recommend them."
Allison R.
Google review
Florida heat won't wait. Neither do we.
Call Fouraker Mechanical now for fast, local HVAC service.